Solo USA Car Video System 1163220 User Manual

NAVIGATING THE SOLO2™ LCD SCREEN  
QUICK REFERENCE GUIDE  
NOTE: This guide is meant to be used only as a brief, general  
reference. For complete operating instructions, always refer  
to the Operator’s Manual.  
Turning Concentrator On/Off  
NOTE: For this procedure, refer to FIGURE 1.1.  
1. To turn the SOLO2 concentrator on, press and hold the  
On/Off button until the three warning lights display  
and the unit beeps.  
2. To turn the SOLO2 concentrator off, press and hold the  
On/Off button  
.
NOTE: GREEN light will flash and you will hear the machine stop  
running.  
On/Off  
Button  
Mode/Return/  
Highlight Button  
Menu Screens Navigation  
NOTE: For this procedure, refer to FIGURE 1.1.  
1. After turning on unit, press and hold the Mode/Return/  
Highlight Button  
to scroll through the three SOLO2  
concentrator menu screens.  
NOTE: Screens will continue scrolling until the Mode/Return/  
Highlight Button is released.  
Normal Operating/Standby Screen  
The Normal Operating/Standby screen shows either battery  
strength gauge, fan operating, external power on and battery  
charging icons, when applicable, or the current/last mode of  
operation and output flow level selected.  
SOLO2™ Quick Reference Guide  
1
 
   
2. To save changes made on the LCD Adjust screen:  
A. Press and hold the Mode/Return/Highlight Button  
until a different screen appears.  
Mode & Flow Adjust Screen  
The Mode & Flow Adjust screen allows user to change the  
current mode of operation and output flow (FIGURE 1.3).  
NOTE: To adjust either the mode or flow, the Mode & Flow Adjust  
screen must be displayed. If the battery level screen is displayed,  
press the Mode/Return/Highlight  
, Up/Increase  
, or  
Down/Decrease button for approximately two seconds (screen  
should change to Mode & Flow Adjust).  
NOTE: Any changes to the setting will not take effect until after the  
screen flashes three times.  
Up/Increase  
Button  
Mode/Return/  
Down/Decrease  
Highlight Button  
Button  
Changing Mode  
NOTE: For this procedure, refer to FIGURE 1.3.  
1. With the Mode & Flow screen displayed, press and hold  
the Mode/Return/Highlight Button  
for one second.  
2. Wait until the Mode & Flow screen flashes three times.  
SOLO2™ Quick Reference Guide  
3
 
Adjusting Flow  
NOTE: For this procedure, refer to FIGURE 1.3.  
1. With the Mode & Flow screen displayed, press and hold  
the Up/Increase Button  
or Down/Decrease Button  
until desired setting is achieved.  
2. Wait until the Mode & Flow screen flashes three times.  
Invacare Corporation  
USA  
© 2010 Invacare Corporation. All rights  
reserved. Republication, duplication or  
modification in whole or in part is  
prohibited without prior written  
permission from Invacare. Trademarks are  
identified by ™ and ®. All trademarks are  
owned by or licensed to Invacare  
Corporation or its subsidiaries unless  
otherwise noted.  
One Invacare Way  
Elyria, Ohio USA  
44036-2125  
800-333-6900  
Technical Services  
800-832-4707  
Part No 1163220  
Rev B - 01/10  
 
 

Sharp Stereo System CP S10H User Manual
Shure Headphones E3g User Manual
Snell Acoustics Portable Speaker K7 User Manual
Sony Car Stereo System CDX 1200 User Manual
Sony Digital Camera 4 187 045 111 User Manual
Sony Flat Panel Television XBR 55HX950 User Manual
Sony Laptop Digital Studio System User Manual
Soundmatters Speaker MAINSTAGE User Manual
Spectra Laser Level LL300 User Manual
Sylvania VCR SSV6002 User Manual